+44 (0) 1580 891521

 

 

MuMetal Deep Drawn Cans Deep Drawn MuMetal Magnetic Shielding Cans

 Cans are normally produced in MuMetal and typically have a wall thicknesses of between 0.5mm and 1mm. Deep drawn products vary in size from less than 10mm round or square to approximately 75mm round or square. We are able to trim the height of any can to suit a customer’s requirements, however there are limitations which directly correlate to the base size/diameter of the can. We therefore recommend that you check with Magnetic Shields that your desired height is possible at the design stage.

 

 

 

We have extensive deep drawing and fabricating facilities to produce both round and square cornered cans in quantities from singular cans to high volume production runs. All of these cans can be supplied with tight fitting lids incorporating custom specified lead through holes to suit individual customer’s requirements.

If you cannot find your requirements in our standard MuMetal can range we can produce tooling to form any deep drawn can in MuMetal or other soft magnetic alloy to order. Typically for a new tool there is a lead time of approximately 6-8weeks but normally we can produce hand-made prototypes of a new design in 2-3 weeks to verify the product prior to any tool cost being incurred.

 

MuCan® Circular

 

 

Notes

All Circular cans available with inside or outside fitting lids

Tolerances +/- 0.25mm (0.010")

• These cans are our current range, however, we are constantly extending our range and it may be possible to manufacture your particular requirements from our standard tooling

 • Piercing/drilling of holes and cutouts can be made as required

• The can depth depicted in the table is the maximum available. This depth can be adjusted to suit your requirements. 

 

Contact Our Technical Sales Team

 

MuCan® Rectangular

  

Notes

Tolerances +/- 0.25mm (0.010")

• These cans are our current range, however, we are constantly extending our range and it may be possible to manufacture your particular requirements from our standard tooling

 • Piercing/drilling of holes and cutouts can be made as required

• Flat lids can be manufactured to your design

• The can depth depicted in the table is the maximum available. This depth can be adjusted to suit your requirements. 

 

 Contact Our Technical Sales Team

 

  

Headcorn Road  |  Staplehurst  |  Tonbridge  |  Kent  |  TN12 0DS  |  UK

Tel : +44 (0) 1580 891521  Fax : +44 (0) 1580 893345

® MuMetal is a registered trademark of Carpenter Technology Corporation
® MuRoom is a registered trademark of Magnetic Shields Limited
® Cryophy is a registered trademark of Aperam Alloys